I was messing around adding SSD's for optimizer (see the sticky thread above) when I started getting errors in adding 2 identical 256GB SSD's, one stopped at 95%, the other gave a message saying can't add same drive.
I accepted an option to apply default settings and now have lost access to the Pool.
The correct pool name is there in a largely blank screen but all the storage drives have the + option to add the drives. I get a message saying can't add the drives if I try.
The pool status bar at the bottom shows no pool when I run the cursor over it.
I think I have messed up Drivepool itself and the information on my normal pool is lost since I can't see the normal display (using W10) - thought I would post here for help before I try to reinstall DP beta version.
I did disconnect the 2 new SSD's since they had generated a message to DL new drivers 55005/-RST. I did try loading them but it came back with a wrong version error.
PC boots OK but DP doesn't load automatically and takes 2-3 minutes to load if I open the link.
Help please.