I swapped out a drive for one with a higher capacity, I used the 'remove drive' option, when complete I then added the larger capacity drive to the pool. Initially it took time to repopulate the new drive and now the pool doesn't seem to have settled and it keeps checking, then duplicating, after duplication has finished it shows the pool is good only for a short time, about ten minutes I would say, then the cycle repeats, checking again and more duplicating, over and over.
I've attached a screenshot of some notifications, (only these few because I cleared them after reading earlier).
The pool seems to fine except for this issue, I'm fairly sure before swapping the drive this didn't happen, is there anything I can do?
I'm using beta v. 2.2.0.765
