So here is my scenario.
I have a drivepool setup with 5 data drives pooled together. My intention was to not use the scanner / drivepool evacuation feature, as I run snapraid daily.
But, I must not have turned that setting off, so when scanner detected the drive failure it evacuated the drive and copied the files to the other drives available.
Snapraid never ran successfully after this happened.
When I got a new drive and added it to the PC, not knowing what drivepool copied successfully I ran a snapraid fix command and recovered all the files from the failed drive.
Now, there are obviously duplicate files across the 5 data drives.
Since my setup was in a state of flux, I decided to do fresh install, upgrade to Windows 10, and run this setup on a dedicated PC rather than in a VM as before.
My question is how will drivepool behave when I re-setup the new pool? Will it detect duplicate files and keep only one copy? Or is de-duping them something I need to take care of manually?
Thanks in advance,
Ken
I have a drivepool setup with 5 data drives pooled together. My intention was to not use the scanner / drivepool evacuation feature, as I run snapraid daily.
But, I must not have turned that setting off, so when scanner detected the drive failure it evacuated the drive and copied the files to the other drives available.
Snapraid never ran successfully after this happened.
When I got a new drive and added it to the PC, not knowing what drivepool copied successfully I ran a snapraid fix command and recovered all the files from the failed drive.
Now, there are obviously duplicate files across the 5 data drives.
Since my setup was in a state of flux, I decided to do fresh install, upgrade to Windows 10, and run this setup on a dedicated PC rather than in a VM as before.
My question is how will drivepool behave when I re-setup the new pool? Will it detect duplicate files and keep only one copy? Or is de-duping them something I need to take care of manually?
Thanks in advance,
Ken